1. Ensure the System is Turned Off
  - Power down the system and unplug it from the power source for safety.
2. Open the Right Panel
  - Loosen the 4 screws at the back of the system and carefully remove the right panel to access the internal components.
3. Loosen the Connector Screws
  - Use an Allen key (size 2) to loosen the 2 screws that hold the connector in place (as shown in Fig 1).
4. Disconnect the Generic Charger Card
  - Use a Phillips screwdriver to loosen the 2 screws securing the generic charger card.
  - Disconnect the white connector (as shown in Fig 2).
5. Disconnect the Black Connector from the CPU Card
  - Disconnect the black connector from the CPU card (as shown in Fig 3).
6. Remove Zip Ties Securing the Harness
  - The harness may be secured with zip ties along the way.
  - Use a cutter to carefully cut the zip ties.
  - Be cautious not to damage any other harnesses or wires while cutting.
7. Install the New Harness
  - Position and connect the new CPU to IPL Harness along the same path as the previous one.
  - Attach the plastic connector holder securely.
8. Reconnect the Harness
  - Reconnect the components in the same positions as the ones you disconnected:
    - Generic Charger Card: Reconnect the 2 Phillips screws and the white connector (red wire for positive, black wire for negative) (see Fig 2).
    - CPU Card: Reconnect the black connector to the CPU card (see Fig 3).
    - Connector: Tighten the 2 screws that hold the connector using the Allen key (size 2) (see Fig 1).
9. Reassemble the System
  - Once everything is securely connected, replace the right panel and tighten the screws.
10. Power On the System
  - Plug the system back in and turn it on to ensure the new harness is working properly.
Let me know if you need any further assistance!
1. - It is important to pay attention to the direction of the connector, the side with the hole in the connector supposed to be at the bottom.

Enter Device Information